I got a new Biqu H2V2 for my Ender 3 pro , since myold hotend started getting unreliable and that was a great excuse for yet another upgrade.
I wasn't happy with the carriage holder I printed, so I wanted to print a new one. After afew hours of printing, I needed to abandon one part, since it was incredibly messy with blobs of PLA gooped on the print. Since I needed the new carriage mount, I didn't think anything off it and simply abandoned that part and continued the other ones.
Today, I saw that the heating block is completely gooped up with PLA (see pictures). So now, I got two questions:
- How should I remove that gunk? I was thinking o| carefully peeling of everything without the silicone sleeve while the hotend is at a low PLA-bending temp, like 150°C, or 175°C.
- What caused this? Flowrate too high (the prints look the part)? Too fast extrusion? Heatcreep?
Thanks in advance. (:
Sort of. As the previous poster pointed out, you need to make sure it’s assembled in a way that the nozzle is seated against the heat break inside the heater block, not against the heater block itself. You’ll have to do a complete disassembly to clean it up properly, and you may need to run a tap through the heater block to clean the threads, but when you assemble it, make sure that you back the nozzle off a turn or so, assemble the hot end so that the heatbreak is bottomed out against the nozzle, then heat it all up and torque the nozzle up snugly to the heatbreak(quarter turn past touching is usually sufficient). There are YouTube vids that will demonstrate hotend assembly better than I can explain it, but solid nozzle to heatbreak seal is critical for preventing this
I've cleaned the outside, but I don't know what you mead by that. Could you explain how I fix the threading?