I'm not sure I understand. What is it supposed to look like.

this looks like its warping from too much heat. you can try:

lowering temperatures, more cooling or slower printing

also is your bed leveled? sometimes this can happen because the extruder is too close on some points but not on others. from that angle it looks like its not warping evenly.

give us more details about your setup if you can, temps, printer type etc.

This can sometimes be caused by uneven cooling. I was able to resolve it by using a fan shroud that cools on both sides of the print.

How fast are you trying to print? Does it behave differently if you slow down?

One of the reasons prints can shrink like this is that the speed is essentially stretching the plastic as it comes out the nozzle, like a rubber band. As the plastic settles that tension pulls it together.

I doubt moisture is the issue, PLA doesn't actually absorb water very quickly.

Also, have you done a temperature tower and flow calibrarion for this filament?

It's been a while since I've printed but I think both my sidewinder and voron do this. I don't remember having it after switching to abs. Painted on supports and wider extrusions helped a ton if I remember correctly. Good luck!

Based on your fans it's more likely too much air + high initial temperature causing uneven cooling. I assume with those fans you're trying to print really fast?

From the brown blobs and warping, it's printing way too hot, which youve probably done to compensate for an overabundance of cooling. Slow the fan, slow down, and lower the temperature.