homeassistant

13552 readers

27 users here now

Home Assistant is open source home automation that puts local control and privacy first. Powered by a worldwide community of tinkerers and DIY enthusiasts. Perfect to run on a Raspberry Pi or a local server. Available for free at home-assistant.io

founded 2 years ago

MODERATORS

GreatAlbatross@feddit.uk

greatalbatross@lemmy.world

Bed Occupancy Sensor? (lemmy.ml)

submitted 1 week ago by Practical_Plan_2560@lemmy.ml to c/homeassistant@lemmy.world

43 comments fedilink hide all child comments

Anyone try to build a bed occupancy sensor integrated with Home Assistant? I've looked into load sensors but all of them seem to have pretty small weight limits (low enough to where I don't think it would even support the empty bed).

What devices/sensors have you used for this? And what does your setup look like?

you are viewing a single comment's thread
view the rest of the comments

[–] rmuk@feddit.uk 1 points 5 days ago

I'm a bit late to the conversation here, but I bought four of these car seat occupancy sensors - https://www.ebay.co.uk/itm/316523892197 - and installed them between the mattresses, one at butt level and the other at shoulder level on both sides of the bed - and connected them to an ESP32 on ESPHome. Works a treat. They're sensitive enough to momentarily disengage if someone rolls over or shuffles about if you need that, otherwise a generous bounce detection allowance smooths it out.