As you can see, it has 2 of each terminal. The supplied wiring diagram only shows one being used. I have two identical 24v strips that I want to dim together - can I just wire them both in?
this post was submitted on 13 Oct 2025
35 points (94.9% liked)
homeassistant
16534 readers
98 users here now
Home Assistant is open source home automation that puts local control and privacy first.
Powered by a worldwide community of tinkerers and DIY enthusiasts.
Home Assistant can be self-installed on ProxMox, Raspberry Pi, or even purchased pre-installed: Home Assistant: Installation
Discussion of Home-Assistant adjacent topics is absolutely fine, within reason.
If you're not sure, DM @GreatAlbatross@feddit.uk
founded 2 years ago
MODERATORS
you are viewing a single comment's thread
view the rest of the comments
view the rest of the comments
Some speaker wire, like 18awg stranded is more than enough to extend to the next led strip, if each of your strips is 40w or so you can run quite a few.
The strips themselves probably can't transmit more than double their own draw, but the strip should tell you max length on it somewhere.