1
you are viewing a single comment's thread
view the rest of the comments
view the rest of the comments
this post was submitted on 20 Nov 2023
1 points (100.0% liked)
Homelab
371 readers
2 users here now
Rules
- Be Civil.
- Post about your homelab, discussion of your homelab, questions you may have, or general discussion about transition your skill from the homelab to the workplace.
- No memes or potato images.
- We love detailed homelab builds, especially network diagrams!
- Report any posts that you feel should be brought to our attention.
- Please no shitposting or blogspam.
- No Referral Linking.
- Keep piracy discussion off of this community
founded 1 year ago
MODERATORS
A pair of 2680v4's certainly didn't decrease your power usage unless you came from Nehalem's.
My 2660v4's in a DL380P G9 idled at 220w. Getting rid of that machine and moving to Alder Lake was the absolute best thing I did for my home server. The new system runs circles around those ancient Xeon's and consumes less than half of the power. I went from averaging 200kwh/mo with the HPE to ~80kwh/mo. $30/mo savings paid for the entire upgrade to a better platform.
ok you got me. The 2680s are in the mail still and should be here next week... maybe friday. It currently has dual 2637s but my idle is 90~100w with just proxmox and 5 SSD and 150w running all my services. Once the processors are in we'll see how it does but since the TDP is less per processor I don't anticipate a jump in consumption.
today my dual E5-2680v4 processors arrived. I installed them with fresh thermal paste and at boot my system idled at 80w... that was according to iLO and a smart power monitor plug that monitors everything plugged into that outlet.
after 5 minutes of run time with 5 - VMs currently running I'm sitting at 120w as a high and 100w average.
My current setup is a DL360 Gen9 with 128gb DDR4. 2 x E5 - 2680 V4 that just replaced my pair of 2637 v3 I should note I don't have any spinning drives installed, only 5 x 128mb sata SSD. I also have an extra 4 port 1gbs PCI card installed and I added p440ar since my server didn't come with a SAS card only the built in sata controller.
Once my slightly longer SAS cables arrive so I can connect the p440ar I'll eventually be at 8x2.5" SAS, 4xsata SSD, 8x3.5" SAS and 4x2.5" sata.
But here we are today running idle at about 100w in my gen9 with a peak of 120w under load.
DL360 ≠ DL380
But you've done a nice job of proving my point. You have a system that you have to hack together your drive storage, since it can't accommodate 3.5" drives. You have have a system that has abysmal single thread performance. You have a system that has overall less compute power than a $240 midrange desktop CPU, yes uses over twice the power. You have a system that has no hardware media encoding.
I'll add, I certainly don't trust ILO to report accurate power draw. Measure from the wall. Each of your CPU's pulls over 120w by themselves alone at 100% utilization. So either your weren't pushing them, or your numbers are off. You should have been pulling 300w at a minimum.