32
My Print won't stick to the Bed[SOLVED]
(lemmy.world)
you are viewing a single comment's thread
view the rest of the comments
view the rest of the comments
this post was submitted on 26 Nov 2023
32 points (100.0% liked)
3DPrinting
15787 readers
55 users here now
3DPrinting is a place where makers of all skill levels and walks of life can learn about and discuss 3D printing and development of 3D printed parts and devices.
The r/functionalprint community is now located at: or !functionalprint@fedia.io
There are CAD communities available at: !cad@lemmy.world or !freecad@lemmy.ml
Rules
-
No bigotry - including racism, sexism, ableism, homophobia, transphobia, or xenophobia. Code of Conduct.
-
Be respectful, especially when disagreeing. Everyone should feel welcome here.
-
No porn (NSFW prints are acceptable but must be marked NSFW)
-
No Ads / Spamming / Guerrilla Marketing
-
Do not create links to reddit
-
If you see an issue please flag it
-
No guns
-
No injury gore posts
If you need an easy way to host pictures, https://catbox.moe may be an option. Be ethical about what you post and donate if you are able or use this a lot. It is just an individual hosting content, not a company. The image embedding syntax for Lemmy is 
Moderation policy: Light, mostly invisible
founded 2 years ago
MODERATORS
To my eyes the inner rectangle portions look pretty good and uniform. If that's a brim around the outer edge it's definitely not doing its job.
Is the severe warping and sharp creases from you fighting to remove it from the plate or is this basically how it looked on the printer?
EDIT: If there's any kind of draft near the printer maybe you could try using a cardboard box or something to build a makeshift enclosure.
Amount of extrusion on the brim looks about right, so first thing I'd make sure is that the first layer gets laid down in a constant distance to the bed. That requires the bed to be level, but also fro the printer to know about how the bed is a bit uneven in places so it can compensate for that.
The FAQ for the printer mention:
This sounds like they did something about the autoleveling in the new firmware release. Make sure you use that, then report back.
Oh! Okay