672
You liar!
(lemmy.world)
Edit It's 17:08 now and it still shows 3 minutes
Edit 2 It's 17:15 now and it has been on 0 minutes for 3 full minutes....
Seems to be a washing machine. 1600RPM spin dry.
The problem occurs because there are 2 conditions that need to be fulfilled.
Its programmed to spin at set RPM for 6 mins.
Before it can initiate a full speed spin it needs to ensure the drum is balanced. If its off balanced it will damage the spin motor and other parts of the machine in short order. (reference old machines that sound like an earthquake during spin cycles). It will keep attempting to adjust the clothes by start-stopping so clothes can fall in place. Only when the vibrations are down to acceptable levels will the machine initiate a full speed spin dry. Machine will stay stuck at set spin time until condition 2 is fulfilled.
The way to fix this is to open up the machine, untangle balled up clothes and allow the spin dry to resume.
I find you get much more accurate estimates when you don't overstuff the machine. You're supposed to keep it 60-70% full to allow for proper agitation. Lots of people top it off.
If you read the instructions, on mine anyway, it says a full load is to the top of the basket without pressing down on any of the clothes. I always lay them around in a circular pattern to even out the level of clothes as I'm loading it. My fiancee used to shove as much as she could in there, and it would get off balance and wobble and shake the house. It took a lot of convincing but she finally believed me after I kept pointing out that's probably why it was happening.
Washing machines (mine anyway) wash by spinning back and forth in water with detergent, so if you stuff it full there's not much room for any clothes to move and they don't get very clean and will come out smelling like laundry detergent.
Sounds like you have top load and not front load.
I'm referring to front load machines.
Ref: https://www.wash.com/wp-content/uploads/2018/10/front-load-max-fill-level.gif
https://www.wash.com/request-help/clothes-not-getting-clean/
Very good reply, just one thing to add, it's both a washer and dryer, we did a full wash dry cycle.
It's even harder to estimate two separate things accurately. So many variables
Even worse... dryers often use a moisture sensor to determine when it is done. Load shifts, sensors gets more moisture, time goes up.
Those are a thing? TIL, how cool!