bike wrench

1060 readers

1 users here now

A place to ask bicycle repair questions, and for bike shop monkeys to share advanced non commercial wrenching resources (no YouTube self promotion). This is only for repair related topics.

!bicycles@lemmy.ca

!micromobility@lemmy.world

founded 2 years ago

MODERATORS

j4k3@lemmy.world

please advise: front hub slightly too big for dropouts... (sh.itjust.works)

submitted 2 weeks ago* (last edited 2 weeks ago) by Grass@sh.itjust.works to c/bikewrench@lemmy.world

2 comments fedilink hide all child comments

I picked up some cheap rims but the part that rests in the dropouts is too wide, I haven't measured it but it looks like it would be possible to use percussive coersion. How dangerous would it be to do that or shave it down just a bit? The fork is aluminum.

I'll add photos when I get back home

you are viewing a single comment's thread
view the rest of the comments

[–] calamitycastle@lemmy.world 1 points 2 weeks ago

Steel you can get away with a bit of flex. Aluminium tubes will weaken if you bend them, do not do it.

Front dropout though it's usually always the same so definitely post some pictures and measurements!