submitted 11 months ago by TapEarlyTapOften@alien.top to c/homelab@selfhosted.forum

1 comments fedilink hide all child comments

I recently had my basement rewired and have a 20A circuit breaker with 12 ga wiring to outlets with two 5-15 receptacles. I'm looking at getting a Liebert GXT3 UPS and having a hard time figuring out which variant I can use with my Dell R730. The power supplies that it came with are each labeled 750W, 80+ platinum efficiency. I can add, so that looks to me like I'll need the GXT3-1500RT for a UPS and I have been told I need to have a bit of headroom on that, but the 2000RT variant datasheet indicates it uses a 5-20P plug which isn't going to work with the outlets I have.

Will a 1500 work for me or do I need to buy two 1000 flavors instead? Is an GXT-1500 going to be sufficient for an R730? I have no idea how much power the server actually draws - those 750W are the power consumption when the supply is pushed to the max, right? The baseline level I need to provide a UPS for doesn't have to match that (plus 10%) all the time does it?

I appreciate any help anyone can give me on selecting a UPS; I don't want to exceed what my wiring is rated for or do anything crazy, I just want to make sure I don't spend a bunch of money on a UPS that isn't going to do what I need or won't work with my setup. Thanks.

you are viewing a single comment's thread
view the rest of the comments

[-] rizon@alien.top 1 points 11 months ago

A 1500 should be fine for you.

Your R730 can be configured in either redundant mode or non-redundant mode for power in the iDRAC settings. If you have it set up as redundant, it will use up to 750W (give or take a small amount for power conversion inefficiency and such) since a single power supply would need to be able to support the entire server if the other went down. In non-redundant mode, you can use up 1500W (again, give or take a small amount) but if one power supply goes down the entire system may go down (I've never personally tried this so not sure what actually happens).

You can also set a power cap in iDRAC settings as well if you want to be extra cautious - this is the maximum power it'll use (give or take a small amount again).

I have a 1500W CyberPower unit that I use for my R730 with dual 750W power supplies (in redundant mode) along with several other things (other servers, networking equipment, tape drives, etc). I draw about 400-500W depending on what I'm doing. I don't use any of the power capping features so theoretically I could exceed the maximum output of my UPS if I were to push all of my stuff to 100% usage but I never do that so it's not an issue for me.

this post was submitted on 19 Nov 2023

1 points (100.0% liked)

Homelab

371 readers

2 users here now

Rules

Be Civil.
Post about your homelab, discussion of your homelab, questions you may have, or general discussion about transition your skill from the homelab to the workplace.
No memes or potato images.
We love detailed homelab builds, especially network diagrams!
Report any posts that you feel should be brought to our attention.
Please no shitposting or blogspam.
No Referral Linking.
Keep piracy discussion off of this community

founded 1 year ago

MODERATORS

communick@selfhosted.forum

rglullis@communick.news