submitted 1 year ago by MeatballFlag@lemmy.sdf.org to c/3dprinting@lemmy.world

7 comments fedilink hide all child comments

This print started fine the first handful of layers before I walked away. I came back later and everyone of these blocks was curling up with the corners lifting off the bed. I just put on the PEI plate, this is the first print on it. I did level the print bed manually with a sheet of paper, the first layers of each block looked nice and uniform. I'm printing with the bed at 60c which is what I've always used with the flexible magnetic print mat that came on the printer. Should I be turning down the bed temp with the PEI plate?

Thanks for any advice

you are viewing a single comment's thread
view the rest of the comments

[-] morbidcactus@lemmy.ca 1 points 1 year ago

To echo others, make sure your print surface is clean and oil free, soap and water with a gentle scrub is good maintenance (unless your surface explicitly says not to, buildtak came with a big warning to only clean with IPA) and absolutely avoid things like acetone to clean it, IPA is alright to clean between batches.

I've not seen pla lose adhesion like that, Do you have some pictures of what your first layer tests look like? Curling I've seen when your nozzle is too close to the surface, some of the worst adhesion issues I've had are because of that specifically on petg and somewhat on abs. But try to eliminate one variable at a time, get your surface oil free and then check your first layer again.

Does it happen everywhere or just on the edges of the plate?

this post was submitted on 17 Jul 2023

9 points (100.0% liked)

3DPrinting

15561 readers

167 users here now

3DPrinting is a place where makers of all skill levels and walks of life can learn about and discuss 3D printing and development of 3D printed parts and devices.

The r/functionalprint community is now located at: !functionalprint@kbin.social or !functionalprint@fedia.io

There are CAD communities available at: !cad@lemmy.world or !freecad@lemmy.ml

Rules

No bigotry - including racism, sexism, ableism, homophobia, transphobia, or xenophobia. Code of Conduct.
Be respectful, especially when disagreeing. Everyone should feel welcome here.
No porn (NSFW prints are acceptable but must be marked NSFW)
No Ads / Spamming / Guerrilla Marketing
Do not create links to reddit
If you see an issue please flag it
No guns
No injury gore posts

If you need an easy way to host pictures, https://catbox.moe may be an option. Be ethical about what you post and donate if you are able or use this a lot. It is just an individual hosting content, not a company. The image embedding syntax for Lemmy is ![](URL)

Moderation policy: Light, mostly invisible

founded 1 year ago

MODERATORS

andypiper@lemmy.world

j4k3@lemmy.world

henry_rowengartner@lemmy.world

GrayBackgroundMusic@lemm.ee