19
Why does filament not stick to the glass?
(midwest.social)
You can see where around corners and even some straight runs it is peeling up. I'm running first layer at an agonizing 15 mm/s. Using hatchbox pla filament, just dried in dehydrator. 200° nozzle and 70° bed. The glass is freshly cleaned with soap and water, I just did several atomic pulls, I've trammed at different heights using a feeler gauge, and absolutely nothing is working. Any one have any ideas?
On top of some of the other tips, layer height being the most prominent, perhaps try a different soap or clean it with alcohol after. I've noticed a difference between soaps (and even between toilet paper brands) - some things leave a bit of residu I think.