635
submitted 10 months ago by throwaway389430@lemmy.cafe to c/news@lemmy.world
you are viewing a single comment's thread
view the rest of the comments
[-] TWeaK@lemm.ee 263 points 10 months ago

Excluding all the ancillary services, including the lasers that maintained the plasma, which was the principle part of this latest test.

Factoring everything in, they're at about 15% return.

This is still very good for this stage, but the publications are grossly misleading.

[-] Pelicanen@sopuli.xyz 97 points 10 months ago

I want to add that experimental reactors used for scientific research might never become net energy positive and that would be fine. Their purpose isn't to generate profit, it's to learn more about the physics, so it will be more valuable for them to be adaptable than efficient.

However, that doesn't mean that you can't take a configuration that has been shown to have potential and make a reactor that is more efficient than adaptable and use that to generate power for the electrical grid.

Basically, they have two different purposes.

[-] TWeaK@lemm.ee 49 points 10 months ago

Absolutely. Also, the fact that the reactor was only running for a short time plays a part. Usually there is a significant energy cost in starting and stopping, which is offset by running for a long time. However, these reactors are not designed for continued running.

It's all a process of development, and even though the article is perhaps a little sensationalist, they're making good progress.

[-] protist@mander.xyz 47 points 10 months ago

but the publications are grossly misleading.

I think you're only referencing the headline, the article itself clearly states what you said

[-] WarmSoda@lemm.ee 8 points 10 months ago

Is the headline not part of an article?

[-] protist@mander.xyz 15 points 10 months ago

When one says a publication is grossly misleading, it certainly implies the entire publication

[-] Chocrates@lemmy.world 14 points 10 months ago

Often the author doesn't write he headline. Not sure it matters but most a bit of info.

[-] CosmicCleric@lemmy.world 4 points 10 months ago

You're not wrong, but we also should stop excusing, normalizing, and accepting wildly exaggerated for sales purposes titles of articles.

[-] intensely_human@lemm.ee 1 points 10 months ago

We should stop accepting lies.

Unless there is some way this reaction actually did produce twice the energy input, it’s not misleading it’s a lie.

[-] Gradually_Adjusting@lemmy.world 11 points 10 months ago

Why have we accepted the standard of misleading headlines? "Oh well you didn't read the article, I guess you and 90% of eyeballs get to be fundamentally misinformed" is an unhinged take.

[-] protist@mander.xyz 4 points 10 months ago

I never said a misleading headline was acceptable. I said the publication is not misleading and that it covers the criticisms dude up above was leveling.

[-] aidan@lemmy.world 2 points 10 months ago

It is misleading, for someone to be misleading they must mislead, and the headline misleads.

[-] intensely_human@lemm.ee 0 points 10 months ago

The headline is part of the publication though.

[-] Cryophilia@lemmy.world 3 points 10 months ago

No, this is a popular science article, not an actual publication.

[-] Cryophilia@lemmy.world 5 points 10 months ago

"article" vs "publication"

Two different things.

The link takes you to an article. Publications are in actual scientific journals, not intended for popular consumption.

[-] Donjuanme@lemmy.world 11 points 10 months ago

What was your question? I only read "is the" and thought I could base my response off of only that.

[-] Socsa@sh.itjust.works 8 points 10 months ago

When I see "publication" I assume it's the actual scientific paper and not the article reporting on said paper.

[-] WarmSoda@lemm.ee 5 points 10 months ago

That's a great point. I absolutely agree with you on that.

[-] Danksy@lemmy.world 7 points 10 months ago* (last edited 10 months ago)

It's easier to nitpick than it is to interact with the actual argument.

I agree with you. The headline is misleading, and I think it devalues the article.

[-] Socsa@sh.itjust.works 22 points 10 months ago

The publications are not misleading, just these headlines.

[-] EchoCT@lemmy.ml 9 points 10 months ago

That's what I came to the comments to find. Thank you. Would have been much bigger news if it was net energy positive.

[-] Feathercrown@lemmy.world 8 points 10 months ago

15% return is still net energy positive isn't it? Or is that not 15% above the input?

[-] nymwit@lemm.ee 3 points 10 months ago* (last edited 10 months ago)

I can't read the full article (paywalled for me) but it references the National Ignition Facility so the way it goes is super lasers blast a tiny hydrogen thing and that creates a tiny bit of fusion that releases the energy. The energy of the laser blast is what's being called the input and the fusion energy released the output. What is misleading is that a greater amount of energy was used create the laser blast than the laser blast itself outputs. If you consider the energy that went into creating the laser blast the input (rather than the laser blast itself), then it's usually not a net positive energy release.

[-] Feathercrown@lemmy.world 2 points 10 months ago
[-] intensely_human@lemm.ee 2 points 10 months ago

What other energy are you referring to? Like warming up the laser?

[-] pixelscript@lemmy.ml 3 points 10 months ago

Remember when incandescent light bulbs were the norm? They worked by sending full line voltage through a tiny tungsten wire that would get so hot that it glows, making some light, but 95% of the energy that gets consumed is frittered away as heat? The high-power lasers needed to make fusion happen are a lot like that.

I believe all this article is saying is that 15% more energy than what came out of the lasers as useful laser light was liberated in the reaction.This completely ignores the energy it took to power those massively inefficient lasers.

I think it also ignores the fact that the 15% more energy liberated wasn't actually, like, harnessed by a generator. I believe (and I may be wrong) this was testing only the reaction itself. Actually hooking that up to a turbine and using it to create energy that is cost competitive with contemporary sources is still a completely unsolved problem.

[-] nymwit@lemm.ee 2 points 10 months ago

pixelscript@lemmy.ml got it, but basically lasers are pretty inefficient. The article I just found said (in a different run of this facility) they put 400MJ into the laser to get 2.5MJ out of it. So that makes the whole firing system what, 0.6% efficient? Your fusion reaction would have to give more than 400MJ to truly be in the positive for this particular setup/method, but again this facility is a research one and not meant to generate power - there isn't even a way to harness/collect it here.

[-] intensely_human@lemm.ee 2 points 10 months ago

Oh so the laser's generating mostly heat and a little coherent radiation, and they're only referring to the coherent radiation as the "energy input" to the process.

Hmm. Kinda sketch.

Especially because that's not trivial. If we have no way of obtaining laser light other than that process, and the laser is the only way to feed the fusion reactor, then that's 100% on the balance books of this process.

[-] Cryophilia@lemmy.world 3 points 10 months ago

From another article: "In an experiment on 5 December, the lab’s National Ignition Facility (NIF) fusion reactor generated a power output of 3.15 megajoules from a laser power output of 2.05 megajoules – a gain of around 150 per cent. However, this is far outweighed by the roughly 300 megajoules drawn from the electrical grid to power the lasers in the first place."

https://www.newscientist.com/article/2350965-nuclear-fusion-researchers-have-achieved-historic-energy-milestone/

[-] Feathercrown@lemmy.world 1 points 10 months ago

That's worded strangely (powering the lasers takes both 300 and 2.05 megajoules?) but oof

[-] alkheemist@aussie.zone 4 points 10 months ago

Powering the laser takes 300 MJ but the actual laser power (the energy in the light) is only 2.05 MJ. The rest of the energy is lost to heat and other inefficiencies. If the laser could be created with 100% efficiency then the input energy would also be 2.05 MJ.

[-] Resonosity@lemmy.world 3 points 10 months ago* (last edited 10 months ago)

Energy can be measured as occurring in different physical phenomena. There is energy in sound waves/packets, energy in light waves/packets, energy in matter, etc.

The 300 MJ number refers to the electrical energy in the form of electromagnetic fields carried specifically through solid conductors via electron movement along the conductors.

The 2.05 MJ number refers to the radiative energy in the form of electromagnetic fields sent specifically through free space/a vacuum (I presume; I didn't read the article, so maybe the laser medium was a vacuum or something else) via photons/waves. No electrons, aside from those in the lasers that create the photons in the first place.

So there is a conversion from electric to radiative energy here.

Start Edit:

And as another commenter said, in this conversion there are losses because materials aren't perfect.

:End Edit

If the 3 MJ radiant energy from the nuclear material was then converted back into electric energy via steam processes, we'd get a comparable number compared to the 300 one.

This is also why you see nuclear/CSP plants quoted in MWt and MWe: there is a conversion that takes place from thermal energy (vibrations of atoms/compounds) into electric energy.

this post was submitted on 06 Feb 2024
635 points (96.1% liked)

News

23634 readers
3440 users here now

Welcome to the News community!

Rules:

1. Be civil


Attack the argument, not the person. No racism/sexism/bigotry. Good faith argumentation only. This includes accusing another user of being a bot or paid actor. Trolling is uncivil and is grounds for removal and/or a community ban. Do not respond to rule-breaking content; report it and move on.


2. All posts should contain a source (url) that is as reliable and unbiased as possible and must only contain one link.


Obvious right or left wing sources will be removed at the mods discretion. We have an actively updated blocklist, which you can see here: https://lemmy.world/post/2246130 if you feel like any website is missing, contact the mods. Supporting links can be added in comments or posted seperately but not to the post body.


3. No bots, spam or self-promotion.


Only approved bots, which follow the guidelines for bots set by the instance, are allowed.


4. Post titles should be the same as the article used as source.


Posts which titles don’t match the source won’t be removed, but the autoMod will notify you, and if your title misrepresents the original article, the post will be deleted. If the site changed their headline, the bot might still contact you, just ignore it, we won’t delete your post.


5. Only recent news is allowed.


Posts must be news from the most recent 30 days.


6. All posts must be news articles.


No opinion pieces, Listicles, editorials or celebrity gossip is allowed. All posts will be judged on a case-by-case basis.


7. No duplicate posts.


If a source you used was already posted by someone else, the autoMod will leave a message. Please remove your post if the autoMod is correct. If the post that matches your post is very old, we refer you to rule 5.


8. Misinformation is prohibited.


Misinformation / propaganda is strictly prohibited. Any comment or post containing or linking to misinformation will be removed. If you feel that your post has been removed in error, credible sources must be provided.


9. No link shorteners.


The auto mod will contact you if a link shortener is detected, please delete your post if they are right.


10. Don't copy entire article in your post body


For copyright reasons, you are not allowed to copy an entire article into your post body. This is an instance wide rule, that is strictly enforced in this community.

founded 2 years ago
MODERATORS