28
What's going wrong with my prints?
(lemmy.world)
Hey,
Still fairly new to this hobby and have lots of ideas but I've got a snag with a few prints now and was hoping someone could help me work out what I'm doing wrong.
The project is small trays for a custom advent calendar but as you can see the corner on the second picture has lifted massively.
This has happened before with a different print too and I never solved that issue either.
Using an Ender 3 Pro with some generic filament from amazon, hot end at 200C (goes stringy any higher), bed was 50C for this print I think.
Any help would be wonderful :)
I recommend using mineral spirits. It's the only thing that has improved bed adhesion. WITH THE HEAT OFF! I don't know that mineral spirit vapors are bad, but they're definitely not good...