282
submitted 8 months ago by erev@lemmy.world to c/asklemmy@lemmy.world

For me it's driving while under the influence. If you couldn't tell, I like me some ganja. However I have long since held the belief that it is utterly insane to drive while under the influence of most substances, with maybe nicotine and caffeine being the exception. All too often I see other stoners smoking and driving, which I simply can't fathom. I've only operated a vehicle once under the influence and it was just to move a U-Haul around the block to a different parking spot, which was such a scary experience while high that I refuse to even consider getting behind the wheel again while high.

you are viewing a single comment's thread
view the rest of the comments
[-] Buddahriffic@lemmy.world 4 points 8 months ago

I took an audio focused CS course in university and for my main project, I evaluated, among other things, the sound quality of various cables and a distortion pedal I had. None of the cables made a noticeable difference, same thing with the pass through mode on the pedal. I didn't set up a crazy long daisy chain to find out if they eventually did make a difference, but I bet even then it wouldn't be a big deal.

And for digital, it's even less so because you need a lot of error before you start mixing up 0s and 1s.

[-] The_Tired_Horizon@lemmy.world 2 points 8 months ago

I've, in my own limited ability, looked at 50m of guitar cable verses 3 and seen a drop off in higher frequencies. Basically lost the "sparkle". Might depend on the cable and other factors though. You put a sine sweep through the signal chain to test it

[-] Buddahriffic@lemmy.world 2 points 8 months ago

It's been a while so I don't remember the specifics exactly, but I believe I used a square wave because it's easier to see frequency dropoff. The more that gets dropped (at least at the high end), the rounder looking a wave you'll end up seeing.

[-] The_Tired_Horizon@lemmy.world 2 points 8 months ago

Now I'm wondering what happens if I use a square sweep to generate an IR on a guitar cab.... 🤔

[-] Buddahriffic@lemmy.world 2 points 8 months ago

I don't know if it needs to be a sweep, even. A square wave technically includes all frequencies to create that instant rise and hold because a freq high enough to rise that fast will also drop immediately after so a slightly lower frequency is needed to cancel that out, which then needs a lower one to cancel it out and so on. So you can see right away just by looking how well the square shape is maintained if all of the frequencies are making it through. If the corners look more rounded, then high frequencies are being lost. If the flat part looks bulgy, low frequencies are being lost. If the flat part looks squiggly, mid-range frequencies are being lost.

Though it is more of a rough brute force approach and a sin wave sweep will give a better idea of specific frequency response.

And I should correct what I said earlier, it wasn't that none of the cables were dropping anything, but that they all looked similar in what they were dropping and there wasn't much of a difference between a 10cm patch cable, a $2 3m cable, or a $30 3m cable.

[-] The_Tired_Horizon@lemmy.world 2 points 8 months ago

If I ever get the space to set it up I might try it all out. I managed to get an IR out of the noise someone's guitar pedal made on a record.

this post was submitted on 15 Apr 2024
282 points (94.6% liked)

Ask Lemmy

27210 readers
1434 users here now

A Fediverse community for open-ended, thought provoking questions


Rules: (interactive)


1) Be nice and; have funDoxxing, trolling, sealioning, racism, and toxicity are not welcomed in AskLemmy. Remember what your mother said: if you can't say something nice, don't say anything at all. In addition, the site-wide Lemmy.world terms of service also apply here. Please familiarize yourself with them


2) All posts must end with a '?'This is sort of like Jeopardy. Please phrase all post titles in the form of a proper question ending with ?


3) No spamPlease do not flood the community with nonsense. Actual suspected spammers will be banned on site. No astroturfing.


4) NSFW is okay, within reasonJust remember to tag posts with either a content warning or a [NSFW] tag. Overtly sexual posts are not allowed, please direct them to either !asklemmyafterdark@lemmy.world or !asklemmynsfw@lemmynsfw.com. NSFW comments should be restricted to posts tagged [NSFW].


5) This is not a support community.
It is not a place for 'how do I?', type questions. If you have any questions regarding the site itself or would like to report a community, please direct them to Lemmy.world Support or email info@lemmy.world. For other questions check our partnered communities list, or use the search function.


6) No US Politics.
Please don't post about current US Politics. If you need to do this, try !politicaldiscussion@lemmy.world or !askusa@discuss.online


Reminder: The terms of service apply here too.

Partnered Communities:

Tech Support

No Stupid Questions

You Should Know

Reddit

Jokes

Ask Ouija


Logo design credit goes to: tubbadu


founded 2 years ago
MODERATORS