overview for DBNinja

Ouija spirits, do you think there should be a bot that sets the final answer in the title? by DBNinja in c/askouija@lemmy.world

[-] DBNinja@lemm.ee 2 points 5 days ago

N

Motherboard swap! by DBNinja in c/3dprinting@lemmy.world

[-] DBNinja@lemm.ee 4 points 1 week ago

If you're sticking with Marlin, I've been very happy with the "professional" firmware. The configurator is pretty easy to set up if you change any hardware like a new bltouch or new hotend if that's your thing.

Dice holder for kiddo. by DBNinja in c/3dprinting@lemmy.world

[-] DBNinja@lemm.ee 15 points 3 weeks ago

47

There's no rule saying dogs can't bowl by DBNinja in c/lemmyshitpost@lemmy.world

[-] DBNinja@lemm.ee 6 points 1 month ago

Don't bring religion into this!

22

Stripped inner thread on 2020 x axis profile for an Ender 3v2 (lemm.ee)

submitted 1 month ago* (last edited 1 month ago) by DBNinja@lemm.ee to c/3dprinting@lemmy.world

18 comments fedilink

So I was attempting to install kevinakasam's belt mod and I'm fairly sure I stripped the thread that holds the M4 screw in the outer right side of the X axis profile (the side without the extruder attached to the tensioner). How screwed am I? Could I get away with trying Loctite red?

Pics for reference!

Edit: Thanks a ton everyone, I'll keep you all up to date when I try to finish the project this weekend!

Arizona toddler rescued after getting trapped in a Tesla with a dead battery | The Model Y’s 12-volt battery, which powers things like the doors and windows, died by DBNinja in c/technology@lemmy.world

[-] DBNinja@lemm.ee 18 points 4 months ago

Not without the 12V. I'm pretty sure most of the internal electronics are dependent on that working. There's an access port so you can "jump" the 12V with another car, which I think would then allow you to open the door though.