Currently, if I add a clip which is taller than the project resolution, kdenlive will scale it down so it's all visible and leave black bars at the side. Is there an option so any extra is just trimmed off instead?

I'm sorry if this is something obvious and I haven't spotted it, I'm a complete novice 😅

Edit: I think I've found what I need. The transform effect, and then "adjust to original size".

This is all I need but please let me know if there is a way to make this the default for a project 😁

When I do an overhang test, I always have this problem at about 35°. Does anyone have a suggestion what could be causing it?

• Slicer: Orca
• Layer height: 0.2mm
• Infill: 0% (this has improved it a lot, I think the infill was causing bulging)
• Outer walls: 2
• Overhang speed: 10 or 20mm/s (both look the same)

Solution: I mistakenly thought overhang speed in Orca was based on overhang angle, it is percentage instead (which makes much more sense for different layer heights). My 10-25% overhang speed wasn't set to slow down and that must translate to about 35° at 0.2mm layer height. I now have it set to 30mm/s and it now looks great 👍 And sorry, I was wrong when I stated the overhang speed 😅

I use rEFInd as my boot manager and sometimes I like to dual boot a new linux distro (just to try out) which I install with a live USB. Unfortunately, after installing, GRUB has always taken the reigns and it becomes a slight inconvenience to get back to rEFInd every time.

Is there some trick that can request grub not to install?

[What prompted me to ask was I tried KaOS yesterday, and during installation it asked what bootloader i wanted and included the option for 'none'.]

Can anyone suggest what might be wrong? I have just changed the clutch and now I am struggling to select gears even when the engine isn't running.

I don't think it's linkage related because it seems to be difficult to select gears just pulling directly on the arms that move the forks too. I don't think I've done anything that should have an effect on the inside of the gearbox, I've removed and refitted the drive shafts and changed the fluid.

Also can anyone confirm my thinking that the clutch and concentric slave cylinder shouldn't be a factor, since the problem exists when the engine isn't running?

Edit: Strangely, after leaving it overnight, gears are selecting perfectly again and I have absolutely no idea why. I didn't change anything 😕

I suppose that should be good news but without knowing what the problem was, I'm not very satisfied. Thank you to everyone for your help.