35

So I'm trying to get my printer to a point where i can pretty consistently turn out high quality prints, but I'm at a point now where i get results like this. These two prints are from the same batch, same print job, and I'm completely clueless on how to fix it. I have an ender 3 v2 with a bltouch, I've adjusted the eccentric nuts, tightened the belts until the tips of my thumb and index finger couldn't tighten them any further, bed is level, using hatchbox pla. I know i can do ironing to fix the cosmetic problem, but I'd prefer to fix the root issue if possible.

you are viewing a single comment's thread
view the rest of the comments
[-] mvirts@lemmy.world 6 points 2 months ago

This is going to sound stupid, but don't forget to activate bed levelling after performing the leveling measurements. Maybe this is a stupid idea but I put M29 L1 and M29 A at the start of my gcode to load the ubl slot 1 mesh and activate it. Before getting ubl I used M420 S.

I spent way too much time frustrated by bad prints before I learned that leveling wasn't active.

[-] fubbernuckin@lemmy.world 3 points 2 months ago

I figured there might be something like this that i hadn't seen. I'll look into it tomorrow, i get the feeling this would cause the inconsistency.

[-] moody 2 points 2 months ago

Not sure how it works with your printer, but with mine on Klipper, after bed leveling I have to save and restart the firmware, and then I have to go back and select the profile that I just saved, otherwise it doesn't use it.

[-] mvirts@lemmy.world 1 points 2 months ago

That ain't right 😹

Maybe try contacting klipper people https://github.com/Klipper3d/klipper/blob/master/docs/Contact.md

Or file an issue if you think it's a bug.

this post was submitted on 30 Sep 2024
35 points (94.9% liked)

3DPrinting

15763 readers
32 users here now

3DPrinting is a place where makers of all skill levels and walks of life can learn about and discuss 3D printing and development of 3D printed parts and devices.

The r/functionalprint community is now located at: or !functionalprint@fedia.io

There are CAD communities available at: !cad@lemmy.world or !freecad@lemmy.ml

Rules

If you need an easy way to host pictures, https://catbox.moe may be an option. Be ethical about what you post and donate if you are able or use this a lot. It is just an individual hosting content, not a company. The image embedding syntax for Lemmy is ![](URL)

Moderation policy: Light, mostly invisible

founded 2 years ago
MODERATORS