It's an idea that's been played with a few times, but there are many energy loss points in such a system, as well as logistics for keeping the "stack" from falling over. The best so far is pumping water up to an artificial lake, but that's still not very efficient.
Yes grandma, it's soft.
I totally trust that cable from scamazon to not be counterfeit.
From the spin on the hammer after it hits his face it looks like there was a lot more energy left, but I'm no physicist so I have no idea where it's from.
Wall wart
Computer fix this code with just enough mistakes that I can charge them to fix it again, just don't make it obvious.
Eh, what's a little famine among friends.
You shut your whore mouth, Han Solo was way cooler.
Mao did nothing wrong.
Don't dead open inside.
This is the second time this has happened. It looks like it added part of the model on to the side. Is it my slicer? I'm using a Creality Halot Mage, and Chitubox 1.9.5 because that is the only slicer I've gotten to work on Fedora that supports my printer that I've found. I'm completely new to all things 3d printing. This is my first printer and that is my sixth print in the picture.
Not buying a Samsung fridge will kill it even quicker.